Marca: Model: WD-G3P800-W
Waterdrop G3P800 Under Sink RO System
Descripción
Model
WD-G3P800-W
Size (L*W*H)
18.06”*5.65”*17.75”
Feed water temperature
41-100℉/ 5-38℃
Feed water pressure
14.5-87 psi/ 0.1-0.6 MPa
Feed water requirement
Municipal tap water
Faucet appearance
Brushed nickel
Max daily production rate
800 GPD
Faucet appearance
Brushed nickel
As far as we know, using well water as a source for our RO systems is not recommended.
The reasons are as follows:
a. Large particles.
Compared to municipal tap water, the well water is rich in large particles, which will clog the filters easily, and shorten their life significantly.
Please note that the filters will still need to be replaced more frequently, even if you have added a pre-filtration system.
b. Composition
The well water has a very complicated composition, and some of them (apart from the large particles) can cause the filter or internal valve to be clogged and prevent the RO system from functioning normally.
c. Water pressure
The well water may not provide the feed water pressure that the RO system requires (14.5 psi min.). Furthermore, the water pressure will be even lower after passing through pre-filtration systems.
Show More Information
What types of water filters are available commercially? Reverse Osmosis Water Filter Osmosis is when water passes through a semi-permeable membrane from a less concentrated saline solution towards a more concentrated one. Reverse osmosis, on the contrary, sees water move in the opposite direction under hydrostatic pressure (applied by a pump). While most of the water passes through the membrane, the dissolved salts, bacteria, and other harmful substances do not. As a result, the water that comes out of the reverse osmosis system usually has 95% to 99% less total dissolved solids (TDS) than the feedwater, i.e., the water that entered into the process initially. Pros: –Low cost –Improves water quality, taste, and odor –Filters down to the lowest micron Cons: –Wastes more water The Waterdrop G3 800GPD reverse osmosis system with uv light produces the purest water with a high bacteria reduction rate. It has an advanced water production technology that makes three cups of purified water with only one cup of wastewater going down the drain. Also, this system has an additional UV sterilizer that kills up to 99.9% of bacteria in water, delivering a better purification performance. It is an excellent water filter for businesses with large capacities – you get up to 800 gallons of pure water every day. Now you can stop worrying about running out of water.What kind of harmful substances does the Waterdrop G3P800 water filter remove?
The RO system comes with an efficient 3-filter setup, alongside seven layers of RO membrane. Therefore, it is effective against all impurities larger than 0.001 microns, such as heavy metals, harmful chemicals, viruses, bacteria, and more.Is UV sterilize necessary for reverse osmosis system?
Yes, it is. Reverse osmosis system is designed to remove over 90% of contaminants from your tap water by forcing the water particles through tiny pores in the reverse osmosis membrane. However, bacteria that isn’t intercepted by RO membrane will still grow in internal waterway and even faucet. UV sterilizer can perfectly solve this problem because it can filter out up to 99.9% bacteria in water. So, it is best to combine UV disinfection with water filtration for the purest drinking water.Do I need to replace the UV lamp regularly?
No, it is not. You can use the lamp for up to 50 years or more. It uses an advanced LED chip with little or no maintenance requirements – a huge upgrade from the traditional mercury sterilizer.Dose Waterdrop G3P800 RO system waste a lot of water?
No, it does not. The reverse osmosis water system is equipped with cutting-edge water-saving technology that guarantees a minimum drain ratio of 3:1. Therefore, for every three cups of pure water you get, only 1 cup of wastewater is produced. This is the highest water-saving capability you will find in reverse osmosis water filters.Can Waterdrop G3P800 RO system be used for commercial?
Yes, you can. The 800 GDP filtration capacity of the filter in this reverse osmosis with uv light means it can conveniently meet the water needs for large households and small businesses like clinics, restaurants, gyms, cafes, and others.Is the Waterdrop G3P800 reverse osmosis pump noisy?
Yes, it does. The pump in this reverse osmosis water filter works silently; you will hardly hear any noise.Do I need plumbing services to install the reverse osmosis system?
No, you don’t. The installation process is quite straightforward.Is this reverse osmosis water filter system unit suitable for well water?
Regarding using our RO unit with well waterAs far as we know, using well water as a source for our RO systems is not recommended.
The reasons are as follows:
a. Large particles.
Compared to municipal tap water, the well water is rich in large particles, which will clog the filters easily, and shorten their life significantly.
Please note that the filters will still need to be replaced more frequently, even if you have added a pre-filtration system.
b. Composition
The well water has a very complicated composition, and some of them (apart from the large particles) can cause the filter or internal valve to be clogged and prevent the RO system from functioning normally.
c. Water pressure
The well water may not provide the feed water pressure that the RO system requires (14.5 psi min.). Furthermore, the water pressure will be even lower after passing through pre-filtration systems.



